TSB: 01-042/07

MULTI-MODEL - FUEL SYSTEM SERVICING PROCEDURE PRECAUTION

APPLICABLE MODEL(S)/VINS

2004-2007 Mazda3 vehicles

2005-2007 Mazda6 vehicles

2006-2007 MX-5 vehicles

DESCRIPTION

During service/removal of fuel system parts on the above vehicles, the memory of the malfunctions and the long-term fuel trim need to be cleared by either disconnecting the negative battery cable or removing the fuse for the PCM and pressing the brake pedal for at least 5 seconds. If not, the old memory remains, which affects the driveability and diagnostic system. The fuse for the PCM is the ENG B fuse on Mazda3/Mazda6 and the ROOM fuse on MX-5 in the engine compartment fuse block.

The above actions are required for the following:

1. When servicing/replacing a fuel system part.

2. When the vehicle experienced an MIL coming on with DTC P2177, P2178, P2187, P2188, P0171, and/or P0172 stored in memory.

Previously, the Workshop Manual for each relevant DTC section mentioned Clear the DTC from PCM memory using the M-MDS. This has now been updated.

NOTE: The radio presets and clock will need to be set on Mazda3/Mazda6 and both front power windows will need to be initialized on Mazda6 if the negative battery cable is disconnected. This does not have to be done if the fuse is removed. On MX-5, the radio presets and clock will need to be set and the steering angle sensor will need to be initialized if either the negative battery cable is disconnected or the fuse is removed. See the Steering Angle Sensor Initialization Procedure in the Workshop Manual.

SUBJECT MODELS APPLICABLE TO THIS PROCEDURE