TSB: 02-001/06

ALL MODELS - MAZDA WHEEL LOCK INSTALLATION - SERVICE TIP

APPLICABLE MODEL(S)/VINS

All Models

DESCRIPTION

Preliminary examinations performed by Mazda North American Operations have found that several wheel locks replaced under warranty have not failed due to manufacturer defects. This bulletin is to outline the proper installation procedures and torque specifications.

Please have technicians pay close attention when installing wheel locks. The wheel locks must be tightened to the Mazda recommended torque specifications for wheel nuts to prevent damaging the wheel lock and/or wheel.

INSTALLATION PROCEDURE

Any wheel locks that are damaged due to improper removal and/or installation will not be considered a manufacturer defect and will not be covered under Mazda warranty coverage.

1. Remove one lug nut from each wheel. If studs are dirty, clean with a wire brush prior to installing locks.
2. By hand, install one wheel lock on each wheel.

WARNING:

3. Using the special key supplied in the wheel lock set and a torque wrench, tighten each wheel lock to the Mazda lug nut torque specified for that vehicle located in section 02-17 WHEELS AND TIRES in the appropriate Workshop Manual.

NOTE:


Copyright © Mazda North American Operations