SSP69 REFLASH - ERROR CODE
‘Timeout,push RESET
Applicable Models
| Model |
Starting S/N |
Ending S/N |
Model Spec |
| MAZDA5 2006-2007 |
1283 |
9536 |
INCLUDES NAVIGATION |
| MX5 2006-2007 |
0060 |
9641 |
ALL |
| CX7 2007-2007 |
0058 |
5591 |
WITHOUT NAVIGATION |
| MAZDA3 2006-2007 |
0013 |
5250 |
ALL |
Related
Category/Subcategory/Symptoms
BODY AND ACCESSORY / ENTERTAINMENT / IMPROPER OPERATION
MTOL - 5311 Dealer Repair
Information
Symptom and Conditions
If
during the beginning of the audio unit re-flash procedure, an error
message saying ‘Timeout,push RESET’ appears, check the following
possible causes:
-
The
Room Fuse was NOT removed before the ignition key was turned to the off
position.
-
Flashing
device connector J302 was NOT installed before J301. Always install
J302 first, then J301 second to the radio flash ports.
-
If using a Dell
Laptop, the Laptop may be getting too warm. Keep laptop elevated to
provide air circulation.
-
Flashing device connectors J301 and J302 may
be reversed in the re-flashing ports in the audio unit.
Repair Procedure
- When
all of the above possibilities have been checked, check the connectors
inside the black box ‘Flashing Device.’
- Remove
the four (4) screws on the bottom of the box; remove the box cover.
- Confirm
the USB port and Serial port connectors are connected and tight.
See photo below:
Copyright © Mazda North American Operations